Misfeed copier E130 In Toshiba photocopy machine

Proce dure

Check item

Result

Measure

Next Step

1

Open the Automatic duplexing unit. Is there any paper in front of the 1st transport sensor?

Yes

Remove the paper.

No

2

2

Is the 1st transport sensor working?

(Perform the input check in the test mode: FS-03- [ALL]OFF/[9]/[B])

Yes

3

No

•        Check if the connector of the 1st transport sensor is disconnected. (J661, J659)

•        Check if the connector CN318 on the LGC board is disconnected.

•        Check if the connector pins are disconnected and the harnesses are open circuited.

•        Check if the conductor pattern on the LGC board is short circuited or open circuited.

•        Replace the 1st transport sensor.

•        Replace the LGC board.

3

Is the 1st drawer feed clutch working?

(Perform the output check in the test mode: FS-03- 201)

Yes

4

No

•        Check if the connector of the 1st drawer feed clutch is disconnected. (J666)

•        Check if the connector CN316 on the LGC board is disconnected.

•        Check if the connector pins are disconnected and the harnesses are open circuited.

•        Check if the conductor pattern on the LGC board is short circuited or open circuited.

•        Replace the 1st drawer feed clutch.

•        Replace the LGC board.

4

1st drawer feed roller Separation roller Pickup roller

•        Check the 1st drawer feed roller, separation roller and pickup roller.

Replace them if they are worn out.